Maytag Dishwasher
Error Codes

F0E1 Control communication loss Medium Panel may show F0E1 or flicker; no cycle will start. View -> F2E2 Stuck key on control panel Low Touchpad shows F2E2 and ignores further input. View -> F3E1 Wash pump / motor fault Medium Tub fills but spray arms do not rotate; no wash action audible. View -> F3E2 Motor control fault Medium JetClean begins the wash but motor speed is erratic; F3E2 appears mid-cycle. View -> F5E1 OWI optical water sensor fault Medium OWI failure causes the control to default to max cycle time since it cannot verify wash water is clean enough to drain. View -> F6E1 No water detected Medium The JetClean starts normally but no water enters the tub; F6E1 displays 2–3 minutes into the cycle. View -> F6E2 Water flow out of range Medium The fill phase begins but the water flow rate is reported as abnormal, causing the cycle to stop within minutes. View -> F7E1 Flow meter fault Medium The dishwasher begins to fill but stops within 2-3 minutes because the flow meter detects no water movement. View -> F8E1 Heater fault — not heating Medium JetClean cycles complete but water never reached target temperature; food residue remains on dishes. View -> F8E4 Heater relay stuck High Tub temperature rises well above the target 140°F. View -> F9E1 Diverter motor fault Medium JetClean cannot switch between spray zones; only one rack is getting spray water. View -> LOC Control lock engaged Low The control panel ignores all button presses because the child lock feature has been activated. View ->