Maytag Washer
Error Codes

DL Lid lock fault Medium The Bravos XL lock solenoid attempts to engage but the lid remains unlocked after multiple clicks. View -> DU Lid unlock fault Medium The Bravos XL completes its cycle but the lid lock light stays on and the lid does not open. View -> F0E1 Drain fault Medium The washer attempts to drain but water remains in the tub, pausing the cycle mid-drain. View -> F1E1 Main control board fault High The machine halts at inconsistent points during wash, fill, or spin — not tied to any specific phase. View -> F2E1 Stuck key on user interface Low No touch command registers; the Bravos sits with F2E1 on the display. View -> F3E1 Pressure sensor out of range Medium The washer fills but cannot confirm the level; F3E1 appears shortly after fill starts or stops. View -> F5E1 Lid switch fault — top-load Medium Pressing Start produces F5E1 instead of water fill. The Bravos lid reads as open even after slamming it firmly shut. View -> F7E1 Basket speed sensor fault Medium The washer enters the spin phase but the drum does not reach the expected speed, halting the cycle. View -> F8E1 Long fill — no water Medium You hear a faint hum or clicking but no water enters the Bravos drum; after 8–10 minutes F8E1 appears. View -> F9E1 Long drain — water stuck Medium The drain cycle stops partway through and water remains visible inside the drum. View -> F21 Long drain — legacy platform Medium The drain pump runs but cannot empty the tub within the allotted time, leaving standing water inside. View -> INT Cycle interrupted Low Normal behavior — the washer safely unwinds the active cycle after the Cancel button was pressed. View -> LF Long fill — legacy code Medium The Centennial or Neptune washer runs through its start sequence but no water flows into the drum, ending with LF after a 10-minute timeout. View -> OL Overloaded drum Low Bravos attempts to agitate but the drum does not move; oL appears within 1–2 minutes of Start. View -> SD Excessive suds detected Low The washer halts mid-cycle because the suds level inside the drum exceeds the safe threshold for draining. View -> UL Unbalanced load Low The Bravos attempts spin, detects imbalance, stops, tries again — several cycles before uL shows. View ->