Maytag Oven Igniter Replacement Cost — What to Expect

A gas oven that takes ten minutes to reach 350 degrees, or one that clicks and glows but never lights the burner, is almost always telling you about its igniter. It is a small part with a short life, and it is one of the cheapest repairs on a Maytag gas range. This guide covers the Maytag oven igniter replacement cost, what separates a weak igniter from a dead one, and the other faults that are easy to confuse with it.

Repair on a Maytag gas oven	Starting cost	What it fixes
Gas oven igniter	from $175	No ignition, slow preheat, gas smell at start-up
Temperature sensor	from $145	Over- or under-heating, F3 codes
Bake element (electric ovens)	from $155	No heat from the bottom of the oven
Control board	from $265	Locked-out oven, F1 and F5 codes

How Much Does a Maytag Oven Igniter Replacement Cost?

A gas oven igniter replacement on a Maytag starts from $175 including parts and labor, according to this site's oven cost guide. That is a starting point, and the final price is confirmed after on-site diagnosis, with a written estimate before any work begins.

That puts the igniter among the most economical oven repairs, in the same band as a bake element at from $155 and below a control board at from $265. The part itself is small, and the cost is mostly the visit and the labor to reach it, which is why the work is worth bundling if the technician is already in the oven for another reason.

How the Oven Igniter Works and Fails

The oven igniter glows orange and, once hot enough, lets the bake gas valve open so the gas ignites. As it ages it can still glow but no longer reach the temperature needed to open the valve. This site's range guidance describes exactly that fault: an oven igniter that glows without generating enough heat, which delays ignition and lets gas accumulate before it lights.

It is different from a surface burner igniter. On MGR gas ranges the burners use an electronic ignition that clicks and sparks, and repeated clicking after the burner is lit usually means a wet or dirty igniter cap after a boilover, not a gas problem. The oven's glowing igniter is a separate part.

• Slow preheat — the oven eventually gets there, but a weak igniter that takes more than 90 seconds to light the gas should be replaced proactively.
• Glows but no flame — the igniter never gets hot enough to open the gas valve.
• Gas smell at start-up — gas reached the burner before ignition happened.
• Soft thump when the burner lights — delayed ignition, which should be addressed immediately.

Can You Wait on a Weak Oven Igniter?

No, and the reason is safety rather than cost. A weak igniter that still glows gives the impression of a working oven while gas accumulates before it lights, so delayed ignition can produce a small burst of flame. The site's range maintenance guidance lists a glowing igniter that fails to open the gas valve as something not to defer, and our Maytag gas range safety guide covers the wider checks.

If you smell gas at any point, leave the kitchen, do not operate switches or flames, and contact your gas utility from outside. A smell that clears when you open windows still needs attention, and any work on the gas valve, orifice or supply line belongs to a gas-qualified technician.

Faults That Mimic a Weak Igniter

Several other faults produce an oven that heats badly or not at all, and the codes help tell them apart. A failed or drifting temperature sensor sends the wrong reading to the control, which is why range F3E0 locks out cooking until the sensor is replaced; on gas ranges it also disables the igniter circuit. A board fault does something similar, locking the oven out or dropping its settings after a power cycle even though the igniter itself is fine.

The practical lesson is to read the display before the igniter. Paying for an igniter when the sensor was the problem leaves the oven just as dead and the bill larger, so ask the technician to confirm which circuit failed and to show you the reading that proved it.

1. Look for a code first — F3E0 means the sensor circuit is open, and F1E0 points at the electronic oven control.
2. Watch the igniter at start-up — it should glow within about a minute and the burner should light shortly after.
3. Note whether the surface burners work — burners that light normally with a dead oven point away from the gas supply.
4. Check for repeat clicking — that is a wet or dirty burner igniter, not the oven part.

What Moves the Igniter Replacement Price

Where the oven sits and how many cavities it has matter more than the part. Built-in wall ovens often need partial cabinet extraction, which the oven cost guide says adds 30 to 60 minutes of labor over a freestanding range oven. A Gemini double-oven range has two cavities with separate burners, so the diagnosis may check both.

• Freestanding range versus built-in oven — access time is the biggest swing.
• Single versus double oven — a second cavity can add checks even when only one igniter has failed.
• Bundled repairs — replacing a sensor on the same visit saves a second trip.
• Parts availability — common igniters are easy to source for current Maytag models.

Is Replacing the Igniter Worth It?

Almost always. The oven cost guide counts igniter replacement among the repairs worth doing on any oven under about 12 years old, and the 50 percent rule makes it easy: a new Maytag single wall oven starts from $900, so a repair has to approach half of that price before replacement is even worth discussing. An igniter sits well under that. For the full framework see our Maytag oven repair or replace guide.

The exception is an igniter failure on an old oven that is also showing a board fault or a recurring sensor code. Then the igniter is the cheap item in a longer list, and our is it worth repairing a Maytag oven guide helps weigh the rest.

Getting a Quote

Ask for the igniter to be tested, not just replaced: a technician can measure how long it takes to open the valve and whether the glow is strong enough. The diagnostic fee starts from $89 and is typically credited toward the repair if you authorize the work. The Maytag oven repair and range repair pages describe what a visit covers, and the oven repair cost guide lists the other common prices. Book a visit or send us the model number and what the oven does at start-up.