What's Included
- Water supply and fill valve diagnostics
- Harvest cycle repair — heater, motor, and ejector mechanism
- Temperature sensor and control board service
- Condenser coil cleaning and fan replacement
- Water filter replacement and water path cleaning
- Bin-full sensor diagnostics and replacement
Maytag MIM ice makers produce up to 50 pounds of ice per day under normal conditions. When ice production stops or slows, the fault is almost always in the water supply, the harvest cycle, or the cooling system. Our technicians carry the common Maytag MIM parts on the truck for single-visit repair.
Water Supply Faults
LO (low water supply) is the most common Maytag ice maker fault. We verify the shutoff valve is open, inspect the inlet screen and water filter, check the fill valve solenoid, and test the water path for flow restriction. Most water supply issues resolve with filter replacement and fill valve service.
Harvest Cycle Repair
A dF (defrost / harvest) fault means ice freezes on the evaporator tray but does not release to the bin. The harvest heater, harvest motor, and ejector arm all can fail. We diagnose and replace the faulty component in one visit.
Cooling System Work
A Hi (high temperature) fault means the ice maker cannot maintain freezing temperatures — usually a dirty condenser, failed condenser fan, or major refrigerant issue. We clean coils, test fans, and diagnose sealed-system faults.
Maytag Ice Maker Error Codes We Service
- E1 — Temperature sensor fault
- LO — Low water supply
- Hi — High temperature / cooling fault
- CL — Cleaning cycle reminder
- bN — Bin full detected
- dF — Harvest cycle fault
Pricing
Typical Maytag MIM ice maker repair runs from $145 including parts and labor. Fill valve replacement starts from $155. Harvest motor replacement starts from $225. Condenser fan replacement starts from $175. On ice makers past year 8 with compressor issues, verify parts and labor cost against replacement.
Common Error Codes
The most frequently reported error codes for this appliance include E1 (Temperature sensor fault), Hi (High temperature alarm), dF (Defrost / harvest fault). See our complete Ice maker error code directory for the full list.
For a complete troubleshooting walkthrough, see our guide to common problems.
Our Maytag Ice Maker Repair Process
- Book: Schedule online or by phone — most appointments confirmed within 15 minutes.
- Diagnostic: On-site inspection with factory-level test procedures — from $89, credited toward repair.
- Estimate: Written, itemized estimate before any parts are ordered — no surprises.
- Repair: Most Maytag ice maker repairs are completed same-day — ice maker assemblies, water inlet valves, fill tubes, and ice level sensors are parts we carry for both refrigerator-integrated and standalone units.
- Warranty: 90-day labor warranty and full OEM parts warranty on every job.
Transparent Pricing
Maytag ice maker repairs start from $175. A blocked fill tube or faulty water inlet valve is typically a lower-cost fix, while a full ice maker module replacement or control board fault runs higher — the written estimate you receive before we start will detail every component and labor charge.